EK Announces Water Block For GeForce GTX Titan Z

Ek Water Blocks has just announced the worlds first Full Cover water block for NVIDIA’s recently released flagship dual-GPU graphics card the GeForce GTX Titan Z. The EK-FC Titan Z will directly cool both GPUs, RAM and VRM as water flows directly over these critical areas thus allowing the graphics card and it’s VRM to remain stable under high overclocks.

EK-FC Titan Z

The EK-FC Titan Z water block also features a very high flow design therefore it can be easily used in liquid cooling systems using weaker water pumps. The base is made of electrolytic copper (bare on nickel-plated – depending on the variant) while the top is made of quality cast acrylic material or POM Acetal (depending on the variant). Screw-in brass standoffs are pre-installed and allow for safe installation procedure. The cooling engine uses refined 0.7 mm wide microchannel structure to even further improve the heat transfer while not sacrificing the famous low hydraulic restriction design.

EK-FC Titan Z

EK also encloses a two-slot I/O bracket which replaces the original three-slot in order to make installation of multiple graphics cards easier.

EK-FC Titan Z

Up to four EK-FC Titan Z series water blocks can be interconnected with EK-FC Terminal which allows for hassle-free piping job. The product is available in three different variants, an aesthetic retention backplate is also available:


About Author